rig out
英 [ˈrɪɡ aʊt]
美 [ˈrɪɡ aʊt]
网络 打扮; 装配; 装扮
英英释义
verb
- put on special clothes to appear particularly appealing and attractive
- She never dresses up, even when she goes to the opera
- The young girls were all fancied up for the party
双语例句
- To use rig arm carry out single wire-line right and left percussion handle drilling tool jamming in soft sandy strata;
利用钻机大、小臂进行单绳左右冲击处理软砂地层夹钻事故; - A test rig is set up and the experiment on the valve is carried out at the room temperature and high temperature. The experimental proportional characteristics are obtained and compared with the simulation results.
搭建了试验台,分别在常温与高温条件下进行阀的特性试验研究,给出了比例阀的比例特性曲线,并与仿真结果进行了比较。 - The paper analyses functions and characteristics of all kinds of workover rig, proposes out existing problems during well workover.
文中分析了各类型号修井机的功能和特点,提出了在修井过程中存在的问题; - The Floormen remove the rig tongs and tie them back safely out of the way.
钻工打开大钳,放置到安全位置并拴牢。 - The sergeant will rig you out.
中士将发给你物品。 - On the basis of cold qualification test, the irradiation tests ( closed capsule and sweep loop rig) of the coated fuel particles for 10 MW high temperature gas-cooled reactor ( HTR-10) were carried out.
在冷态性能检验合格的基础上,进行了10MW高温气冷堆包覆燃料颗粒的静态辐照试验和动态回路辐照试验。 - Taking the purchase of a deepwater self-elevating drilling rig as an example, a synthetic probability model is set up to carry out the economic risk assessment.
以某海洋钻井公司购置自升式深水钻井平台为例,建立了海洋平台购置项目经济风险评估的综合概率模型。 - In the paper, a modal analysis of JJ 160/ 41-k rig derrick is carried out by applying I-DEAS software being of mighty finite clement analysis function.
文章运用I-DEAS软件强大的有限元分析功能,对JJ160/41-K型钻机井架进行模态分析。 - Secondly the mathematical models of this experimental rig were established and relative operation simulation researches were worked out.
其次以此试验台为对象建立了相应的数学模型,并进行了相关运行工况的仿真计算研究。 - The following aspects have been carried out in the design of an AC servo feed system experiment rig based on Motion Controller with FPGA in this thesis: ( 1) A kind of AC servo feed system scheme is given out.
本文在设计这个基于FPGA运动控制器的交流伺服进给系统试验台上主要做了以下方面的研究:(1)设计了一种交流伺服进给系统方案。
